Swiffer SweeperVac Battery Replacement (PG3000)
This guide will show you where to unscrew, how to split the device apart, and then how to disconnect a failing battery from the rest of the interior electronics.
Выберете то, что вам нужно
Шаг 1 Battery
Unscrew seven 17.95 mm screws on the side of the device.
Unscrew the 13.87 mm screw.
Шаг 2
Find the sticker on the back of the device. It may have already been removed.
If there is a sticker, peel it back from either half of the device.
Шаг 3
Firmly, but carefully grip each half of the case and split it open.
Шаг 4
Remove the silver-colored battery cap from the top of the battery.
Шаг 5
Lift the attached battery from the device and place it on the surface.
Remove the second silver-colored battery cap from the bottom of the interior of the device.
Шаг 6
Using the spudger, apply pressure to the lock on the black wire attachment.
While pressure is being applied to the lock, pull the black wire away from the battery.
Шаг 7
Using the spudger, apply pressure to the lock on the red wire attachment.
While pressure is being applied to the lock, pull the red wire away from the battery.
When installing the new battery, you do not need to press down on the locks. Simply plug the wires into the appropriate sockets on the new battery.
Почти готово!
To reassemble your device, follow these instructions in reverse order.
Заключение
To reassemble your device, follow these instructions in reverse order.
Дать автору +30 очков! Вы закончили!
15 человек успешно провели ремонт по этому руководству.
Автор
Alexander Boesenberg
Участник с: 09/22/14
Автор 3 руководств
Команду
USF Tampa, Team 10-3, Brown Fall 2014 Участник USF Tampa, Team 10-3, Brown Fall 2014
Автор 9 руководств
11 Комментариев
Добавить комментарий
This seems very easy. Will try amd make an update
This was helpful but my swiffer vacuum had a plastic chassis for the battery and I had to remove the circuit board as well to route the wires on my replacement battery as they were not is the same places as the factory battery.
